Job: Field Service Engineer (Electro-Mechanical)

Job Location(s): Milwaukee
Employment Term: Regular
Employment Type: Full Time
Hours per Week: 40-50
Work Hours (i.e. shift): 1st
Start Date: ASAP
Starting Salary Range: DOE
Salary/Benefit Notes: Salary plus travel pay incentives
Required Education: Associate Degree
Required Experience: 3 to 20+ years
Related Categories: Engineering - General, Engineering - Mechanical, Maintenance - Machines
Position Description

Field Service Installation/ Start-up Engineer (Electro-Mechanical)

Due to expanding electro-hydraulic business, our client is seeking additional mechanical installation / start-up engineers for large systems work.
Extensive international travel (50-70%). Will fly out of Milwaukee. Majority of time in customers' plants installing and starting up large industrial electro/hydraulic integrated systems.
Will work in-plant testing systems when not traveling.

Requirements:
* Three years industrial experience
* Previous experience with international field service required
* FPA Fluid power specialist certificate or AS in Fluid Power or Mechanical Technology
* Hydraulic troubleshooting experience
* Piping & tubing fabrication experience

Following experience preferred:
* Troubleshooting and start-up of the following presses: forge, aluminum or Copper extrusion, deep draw, particle board, SMC, ASEE or equivalent
* Thorough knowledge of current Allen Bradley PLC's
* Ability to program logic on any Allen Bradley products
* Network experience

Installation Phase
* Supervise personnel from all trades groups to install equipment
* Rig heavy pieces safely
* Locate large items precisely
* Engineer changes as necessary
* Experience with pipe welding and tube bending essential
* Knowledge of hardware for standard SAE, and DIN Flanges, forged fittings, specialty flanges and tube fittings as well as BSPP, BSP, NPT, JIS, and metric straight and flared thread
* Compression fitting, and welded tube expected
* Ability to use volt-ohm-millammeter and perform basic wiring
* Will read electrical prints/schematics as necessary
* Compose daily and weekly written reports
* Produce installation that is square with proper fitting

Start-up Phase
* Site safety final inspection of the installation
* Troubleshoot all components and be able to disassemble, clean & re-assemble
* Strong all-around mechanical aptitude /
ability
* Must know proper reservoir design, shaft alignment procedures
* Will be trained on electrical side to independently do entire start-up including PLC programming, and MCC start-up.

Starting salary in the $50's/k range.

Qualified candidates call Kermit Kapp at Argus Technical Services 414 773-0639
E-mail resume to kermitk@argus-tech.com

Contact InformationE-mail resume to kend@argus-tech.com